How to set each display panel to a different color?
Answer: Pair the remote control with the corresponding RGB frame one-to-one to achieve different colors for each display panel.
!!! Friendly reminder: Without one-to-one pairing, the remote control is universal
Steps:
(1) Power off all display panels.
(2) Power on only one frame that needs one-to-one pairing at a time. Press and hold the on the corresponding remote control for 3 seconds until the LED strip flashes three times—this indicates successful pairing. Turn off the frame immediately after pairing.
(3) Repeat this process for all frames. Once all frames are locked, power on all frames to complete the one-to-one pairing.
(4) To cancel the one-to-one pairing mode for all frames: Power on all frames, press and hold the for 3 seconds until the LED strip flashes three times—this indicates successful unpairing.
The power supply must provide a voltage of no less than 5V. Thanks to USB power supply specifications, there is no need to worry about excessive output voltage damaging the LED strip.
(1) A power bank or mobile phone charger can be used for power supply.
(2) It can be directly powered using a power strip with a USB interface.
(3) The use of a battery box for power supply is not recommended, as battery boxes have limited stored power, which may lead to insufficient voltage. Voltage below 5V may cause abnormal lighting, unresponsive remote control, and delayed lighting reactions. Excessive voltage may damage the light strip.
Contact:
If you encounter any issues during use, please contact our customer service promptly for assistance.
